Vickie Lou Designs: Let it Snow! Snowman Seasons Christmas Gift Box

Friday 4 October 2019

Let it Snow! Snowman Seasons Christmas Gift Box

Good Morning Everyone

I have such a cute project today, it's a great little gift box decorates with the sweetest snowmen!! The dimensions when finished are 2 1/2" x 1 3/4" x 1 3/4" so there's loads of room inside for goodies and treats.

Measurements

Real Red cardstock
1pc - 8" x 7"

Let it Snow Speciality designer series paper
4pc - 2 3/8" x 1 5/8"
1pc - 1 5/8" x 1 5/8"

Take your Real Red cardstock and score on the long side at 1 3/4", 3 1/2", 5 1/4" and 7" then on the short side at 1 3/4", 4 1/4" and 6".

Now taking a pair of snips, you need to cut along score lines and remove some pieces. See below...

Add the rectangular panels to all four of the middle sections. Stamp the sentiment directly in to your square of DSP and add to the lid section. Make sure you pop it so it reads upside down as you look at the cardstock, so once built it's the eight way round. You should end up with your cardstock looking like this...

Using the 1" circle punch, add a small notch to the panel second from the right. See above.

Add tear and tape to the tab on the left hand side and fold round and adhere to the opposite side.

Fold in the sides, and the back then fold over the front flap and adhere. I would put adhesive on all the flaps if you arw considering putting something a little heavier in.

Stamp out four snowmen and cut using the coordinating punch, also stamp and cut 8 arms. Colour in the buttons and nose on the snowman and adhere one to each panel, add the snowman's arms and you are good to go.

Here's a list of all the supplies I used in today's card, click on the images to head over to my online store
Product List

Thanks for joining me today, I hope you will give it a try. Please click to follow button or subscribe by email to be notified each time I post a new project!!

See you soon

Vickie
xxx