Sunday 1 December 2019

Merry Christmas Snowman Card using Stampin Up Products

Good Afternoon Everyone,

How is your Sunday treating you. We have had a relaxed morning, but next job is a good clean up ready to pop the Christmas Decorations up this evening - I'm so excited... now we have little Imogen, it just seems so much more fun!

Talking of Christmas, I have another Christmas Card to share with you. I'm using the Let it Snow DSP and the Snowman Season's stamp set, I know I only just showed you one with those, but I wanted to show you the amazing variety of cards you can use with this suite of products.

It also happens to fit this week's sketch challenge on Stampin for All on Facebook so I feel it's a  Win Win!



Measurements

Coastal Cabana Cardstock
1pc - 4 1/8" x 11 3/4", scored at 5 7/8"

Let it Snow DSP
1pc - 5 5/8" x 2 3/4"
3pc - 2 1/2" x 1 1/2"
Scrap from the hat print.

Whisper White Cardstock
1pc - 5 5/8" x 3 7/8"
Scrap for the Snowmen

Create the card base by folding the coastal cabana cardstock alomg the score line and burnish well.

On the large piece of whisper white, stamp some of the snowflake images in the bottom right hand corner, then add this panel to the inside.

Ink up the sentiment in memento ink and stamp in the centre on the card front, as low down as you can. Add some snow flakes to either side in Coastal Cabana, making sure not to stamp too far up.

Adhere the larger DSP piece to the top of the card, making sure you have an even border around the top and two sides, there should be a reasonable sized gap between the bottom of the DSP and your stamping. Next adhere the three contrasting panels of DSP onto the card front. These should overlap and cover that blank space.

Stamp three snowmen onto scraps of whisper white and cut out using the Snowman Builder punch, also cut out 6 arms in early espresso. Taking the scrap of DSP punch out three of the printed hat's with the same punch.

Colour in the snowmen using a selection of blends and add the the three panels using dimensionals,add a tiny bit of glue to the back of each arm and place accordingly. Finally, add the punched out hats.


Here's a list of all the supplies I used in today's card, click on the images to head over to my online store,


Product List
Thanks for joining me today, please click follow or subscribe by email to be notified each time I post a new project.

Also, if you get a chance pop on over the Stampin for All on Facebook and see what it's all about. It's a fantastic community full of brilliant crafters, who are there sharing tips, tricks, advice and inspiration.

See you soon

Vickie
xxx

No comments:

Post a Comment

The Project Share Project - 18th April 2024

  Good Morning Everyone, Happy Thursday and welcome to The Project Share Project.  Every Thursday we will all share an individual blog post ...